Aircooled Volkswagen Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
56 Posts
Discussion Starter · #1 ·
I'm building a low budget 84x94 motor. Looking for a pair of low budget but we'll done "sweep the floor heads" 42x37 valves or larger. A nice oval port or bigger, this may be a tall order but 50 cc's or bigger in the chambers would be nice, but I'd consider anything. I can have them bored for 94's or cut for dual springs so that isnt an issue. I hope someone can help me out!!

I'd rather not drop the cash on a new set of cb heads just to cut them for more compression, and have to buy another set later of If I turbocharged this motor so I'm looking for something to get me by w8th ida's until the time goes to turbocharge.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top