Aircooled Volkswagen Forum banner
Status
Not open for further replies.

ProMach Billet crankshaft from Australia

2K views 6 replies 2 participants last post by  Brian Watts 
half finished cranks

Clean out time
things have been sitting in the corners to long
have 6 cranks all in different stages of finish
#1
type 4 mains ,2" big ends, 90 mm stroke ground oil passages done needs fly wheel bolt pattern

#2
2.75 mains ,2" big ends, 80 mm stroke needs grinding and oil holes fly wheel bolt pattern

#3
main type 4 ,2" big ends ,90 mm stroke oil hole done , needs grinding fly wheel bolt pattern

#4
mains type 4 , big ends would end up under 48.4 dia '86 stroke ,needs grinding oil holes fly wheel bolt pattern

#5
Pauter crank 2.1 big ends , 94 mm stroke oil holes needs grinding fly wheel bolt pattern

#6
Pauter crank 2.0 big ends , 64 stroke needs oil holes ,fly wheel bolt pattern only one throw has been roughed in

Make me a good offer and they are out off here
freight is a extra

greg
 

Attachments

Status
Not open for further replies.
You have insufficient privileges to reply here.
Top